Sensor Safe Gasket Maker is an early generation RTV developed for oxygen sensor equipped engines.

• Sensor safe
• For oxygen sensor equipped engines
• Use as gasket maker or dressing
• Resists up to 650f intermittent

Warning: Uncured sealant causes eye and skin irritation. Use in a well-ventilated area. In case of skin contact, wipe off and wash with soap and water. In case of eye contact flush with water for 15 minutes; get medical attention. If swallowed, do not induce vomiting. If overcome by fumes, get fresh air. See Safety Data Sheet for complete GHS hazard communication. Keep out of the reach of children.

Usage Instructions: Directions: 1. For best results, surfaces should be clean and dry. 2. Cut nozzle and apply a continuous 1-16' to 1/4' (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 3. Let dry for one hour then tighten to torque specifications. 4. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. Replace cap after use. Note: Not recommended for use on head gaskets or parts in contact with gasoline.