Permatex® Gap Filling 5 Minute Epoxy
A two-part, rapid curing, clear, general purpose epoxy. May be used as a metal filler and to restore rotten wood. Resists water, gasoline, diesel, kerosene, and most other chemicals.
- Set time: 5 minutes
- Cure time: 4 hours
- Up to 3400 psi strength
- Dries clear
- Water resistant, non-shrinking formula
- Bonds chrome, fabric, fiberglass, glass, plastic, metal, and rubber
- Adhesive & sealant
Warning: Caution: Contains epoxy resins and mercaptan amines. Avoid contact with eyes and prolonged contact with skin. Wear gloves while using. Do not breathe vapors. For eye and skin contact, flush with water for 15 minutes; call a physician. If swallowed, do not induce vomiting; call a physician. See Safety Data Sheet for complete GHS hazard communication. Keep out of reach of children.
Usage Instructions: Directions: 1. For best results: Roughen, remove any grease and oil, clean and dry surfaces to be joined or repaired. 2. Remove plastic mixing paddle from center of black plunger. Turn nozzle end up and pull plunger back slightly (1/8in). Allow air bubbles to rise to top. Snap off an save storage cap. 3. Push plunger evenly to dispense equal amount of hardener and resin onto a discardable surface such as a piece of cardboard or the plastic container on the front of this package. Pull back plunger to stop flow. 4. Mix thoroughly with paddle provided. 5. Apply to surfaces to be joined or repaired. Epoxy starts to set in 5 minutes and reaches usable strength in 4 hours. Wipe nozzle clean. Replace cap for storage. Note: Not recommended for use on polyethylene or propylene plastics. Temperature Range: -60F to 180F (-51C to 82C).